7 steps to soundproof your condo

Enjoy home theater without bothering neighbors

By Inman News Feed
Add Comment Add Comment | Comments: 0 | Posted Jan. 18, 2012

Share this Story:

Enjoy home theater without bothering neighbors

Bill and Kevin Burnett
Inman News®

Q: I finally saved enough money to buy and install a home theater in my duplex condo. The picture on the big screen is amazing and the sound from the six speakers is even better. I have three front speakers and a subwoofer on the floor and two surround speakers mounted in the ceiling. I love it.

Unfortunately, my neighbor doesn't feel the same way. Whenever a movie soundtrack gets a little loud, say the Martians attack or the earthquake and tidal wave hit, she pounds on the wall. Once she even came over and threatened to call the police.

What can I do? I want to be a good neighbor, but I also want to enjoy my new toy.

A: We doubt you'll be able to fully soundproof your condo, at least not without hiring an engineer, a contractor and spending a whole lot of money. So we suggest you sell it and move to a single-family house on 5 acres of open land.

If that's not an option, there are a few steps you can take to dampen the sound and keep your neighbor at bay. Some are relatively inexpensive; others are free.

What's bugging your neighbor is vibrations from sound waves that strike your wall and ceiling, then reverberate through the wall and attic to her space. Your goal should be to isolate and reduce these vibrations.

First, you should build a new sound wall. This will be the most time-consuming and expensive job, but it's pretty much mandatory, especially in a condo. Take these steps:

1. Build a standard 2-by-4 wall with top and bottom plates and studs on 16-inch centers. Make sure it's parallel to the existing wall, leaving 1 to 2 inches of dead space between the two walls.

2. Reroute your power into the new wall. Installing a 2-inch flexible conduit will make it easier to run your wiring to components and speakers.

3. Install the insulation. Owens Corning manufactures fiberglass sound attenuation batts that are designed specifically for use in interior partition systems. You can find this product and lot of other good information on sound attenuation at this link.

4. Finish the wall with sound-dampening wallboard. Make sure any seams and cutouts for outlets are sealed up tight. You should use special sound-dampening products for this job. These materials will cost up to four times more than a standard drywall wall, but they're absolutely worth the money. Bill did a similar project a couple years ago and was pleased with products from a company called QuietRock.

Once your wall is built, there are three more little jobs you'll need to do:

5. Sound from your in-ceiling surround speakers is probably leaking into your neighbor's space through the attic. Consider adding speaker enclosures here. A number of choices are available. Start by doing a Web search for "in-ceiling speaker enclosures."

6. Low-frequency sounds from your subwoofer may be a major source of your neighbor's headaches. If your sub is against the common wall, move it as far away as possible. No need to worry about this degrading the quality of your sound.

7. Finally, make certain your speakers -- especially your subwoofer -- do not sit directly on the floor. Use speaker stands or do a Web search for "sound isolation cones."

These steps won't solve your problem completely, but if your neighbor is at all reasonable, you should be able to coexist. Why not nuke up a batch of popcorn and invite her over for the next feature presentation?

                                     

Contact Bill and Kevin Burnett:
Email EmailLetter to the Editor Letter to the Editor
 

Page: 1 2 |Next
Add to favoritesAdd to Favorites PrintPrint Send to friendSend to Friend

COMMENTS

ADD COMMENT

Rate:
(HTML and URLs prohibited)